Rimpact EDH/PRO V2 Insert Set with Valves
Rimpact EDH/PRO V2 Mix Insert Set
- 1x EDH Tyre Insert (for the Rear)
- 1x Pro V2 Tyre Insert (for the Front)
- 2x 44mm, 55mm Rimpact Insert Compatible Valves
- 4x Vinyl Rim Decal Sheets
- 60mm Wide
- 8mm Pro layer
- Compatible with 2.4” – 2.8” tyres
- Compatible with 30mm – 40mm rims
- Optimized around 35mm rims and 2.5” tyres (narrower set ups will be much harder to install)
- 180g in 29” and 170g in 27.5”
- 55mm Wide
- 6mm Pro Layer
- Compatible with 2.4” to 2.6” tyres
- Compatible with 25mm – 35mm rims
- 160g in 29” and 150g in 27.5”
Like our Pro insert, the EDH utilises a dual density design with a dense protection shell that helps dissipate extreme forces in combination with our classic Original foam that cuts vibration. Crafted from high-quality closed cell foam, the Rimpact EDH is engineered for maximum durability and resilience. Its unique design provides unbeatable impact absorption, reducing the risk of tyre damage and giving you the confidence to tackle any line with confidence.
But the EDH isn't just about protection – it also delivers unrivalled support, vibration damping and run flat performance. Its optimized shape enhances traction and stability, giving you the grip and control you need with heavier Ebike chassis and higher speed DH runs. We’ve upped the durability too, allowing it to resist the rotational forces provided by the motor and last much longer as a result.
The Pro V2 insert is a cumulative update to our Pro insert that has been reviewed so highly by media outlets worldwide. Want the ultimate protection, support and weight ratio out of your insert? Look no further than the Rimpact Pro V2. Its dual layered design gives the best of both worlds, maximum protection and support whilst being light, easy to fit and adept at vibration damping.
Rimpact Inserts must be used in conjunction with an insert compatible valve.
The EDH is Optimized for 2.5” tyres and 35mm internal rims. Whilst compatible with narrower set ups, fitting difficulty increases dramatically for smaller sizes. Unless adept at insert installation, the Pro V2 will be a more appropriate option for 2.4” and 30mm rims.
Use about 25% more sealant than recommended on the bottle to ensure the extra surface area of the insert is coated with plenty of fluid to spare. Our inserts are closed cell and cannot absorb liquid however some sealant will cling to the outside of the insert requiring a slightly higher dosage. It can be injected through Rimpact Valves but is best poured directly into the tyre.
Please follow installation instructions prior to fitting/removing. There is a QR scan code on the packaging that will link you to the installation page of this website.
Disclaimer: It is not advised to run air pressures outside that of the tyre manufacturers recommendations. Failure to do so may result in injury or the premature failure of the bicycle.Rimpact does not accept any responsibility for misuse of the Rimpact Insert or improper installation. Rimpact Inserts are designed to work WITH Rimpact Insert Compatible Valves.
Not included: Tyres, Wheelset.